Pin Code Override Procedure; Pin Code Override Example - Gemini 953 Installation And Use Manual

8.0 - PIN CODE OVERRIDE
If you cannot disarm the system from the remote control or with the electronic
key (remotes are lost or broken or batteries are flat), you will be able to disarm
the system by using the PIN override procedure. Override PIN Code is entered
by means of the ignition key.
For security reasons, we recommend that you change the PIN Code from the
factory default setting 1-1-1-1 (s ee chapter 10). It can be set to any number
between 1 and 9.
To override the system:
!
Trigger an alarm condition. As soon as the alarm ceases, the status
will turn ON steady for approx. 5 ".
!
While the LED is ON, turn ignition key ON and then OFF
CAUTION
If the ignition key stays in the "ON" position for more than 5", the system
will interpret the situation as a theft attempt and trigger another alarm.
!
The status LED will turn OFF to confirm the system is in disarm mode.
!
4" after the LED has turned OFF, it will start flashing a series of 9 blinks
!
At the number of flashes equal to the PIN Code 1st digit, turn ignition key
ON and OFF. This will confirm the entered digit
!
After 4", the LED will flash again 9 times
!
When the number of flashes is equal to the PIN Code 2nd digit, turn ignition
key ON and OFF .
!
R epeat the above steps for the remaining two digits
!
If the code has been entered correctly, the system will disarm and signal the
last cause of alarm as indicated in paragraph 4.11 "System disarming with
alarm memory" .
CAUTION
If the LED blinks more than 9 times, the procedure will be invalidated and
considered a theft attempt.
Page 9
LED
.
.
.
.
.

9.0 - PIN CODE OVERRIDE EXAMPLE

To help you understand the override procedure by PIN Code, here below is a
step-by-step example entering PIN Code 2-3-4-1.
Arm the system, wait for the end of arming delay and then trigger an alarm
condition.
Key "ON"
When the alarm condition is over, the status LED turns ON steady for
approx. 5". While the LED is ON, turn ignition key "ON" and "OFF"; the
LED will turn OFF to confirm the system is in PIN Code disarm mode.
LED steady
Key "ON"
for
"ON"
approx. 5"
The LED will start blinking 4" after turning OFF. Count the flashes and turn
ignition key ON and OFF when the number of flashes
equals the PIN Code 1st digit (in this case 2).
After 4" the LED will start blinking again.
Count 3 blinks (3rd digit) and turn ignition key ON and OFF.
4 sec 4 sec.
.
st
1 digit: "2" "ON" "OFF"
After another 4" the LED will blink again. Turn ignition key ON and OFF
when the number of flashes equals the other 2 digits (4 and 1).
4 sec
.
rd
3 digit : "4"
If the PIN Code has been entered correctly, the alarm system will disarm
and indicate the last cause of alarm.
Key "OFF"
Alarm condition
LED "OFF" to
Key "OFF"
confirm override
mode
nd
2 digit : "3" "ON" "OFF"
4 sec.
th
"ON" "OFF" 4 digit :"1" "ON" "OFF"
Page 10