Developing Applications For Your Linea Pro 7; Programmable Options - Infinite Peripherals Linea Pro 7 User Manual

DEVELOPING APPLICATIONS FOR YOUR LINEA PRO 7

Software is not provided with your Linea Pro 7. Please contact your reseller or Infinite Peripherals for
Third Party software solutions.
Integrating the Linea Pro 7 into your iOS application requires the use of the Infinite Peripherals
Universal SDK. The SDK incorporates an API specifically for developing applications to use Linea Pro
7 functionality.
For additional details on using the Infinite Peripheral Universal SDK, please refer to the appropriate
SDK documentation.
For the latest Infinite Peripheral Universal SDK please visit our developer portal at:

PROGRAMMABLE OPTIONS

Below are optional settings for the Linea Pro 7 which can be configured via the SDK.
Programmable Options
Charging Current
Set Charging
Enable Scan Button
Scan Mode
Pass Through Sync
Idle Time
Linea Pro 7 User Manual
UM-00028 Version: A
https://developer.ipcmobile.com/
Charging current may be set to 500mA (default) or 1A
The Linea Pro 7 can charge the iPhone 7 using its internal battery by
enabling the "setCharging" setting. When the Linea Pro 7 battery is
above 20%, it will then start to charge the iPhone 7 battery
In order to scan, the Enable Scan Button option must be set in the SDK.
Linea Pro 7 the following Scan modes:
• Single Scan
Scanning a single barcode by pressing and releasing either Scan
button.
• Multi Scan
Scanning multiple barcodes by pressing and holding either Scan
button.
• Motion-Detect
Scanner is activated automatically when barcode is placed near the
barcode engine.
• Multi-Scan without Duplicates
Scanning multiple barcodes without duplicates.
When the pass through sync setting is enabled and the USB Type-C
cable is plugged in, the iPhone 7 may be synced with a PC or MAC.
When syncing is required, enable the Pass through Sync setting in the
SDK. When this option is selected and the USB cable is plugged in, the
Linea Pro 7 will disconnect and the user will no longer be able to scan.
In order to use the scanner again, the USB Type-C cable must be
removed.
Default setting is 5400 seconds (90 minutes).
Description
Page 13 of 30