Infinite Peripherals Linea Pro 6 How To Use

Hide thumbs Also See for Linea Pro 6:

How to Use Linea Pro 6 Scanner

Top Side

Dual Purpose Scan Button

The Linea Pro 6 uses a single dual-purpose scan button to power on the

unit as well as scanning barcodes. When the Linea Pro 5 is left idling

for an extended period, the power is automatically turned off to

preserve the charge in the internal battery pack.

Power On

When the Linea Pro 6 is in the off mode, pressing the scan button

momentarily turns on the unit. A single beep indicates the Linea Pro 5

is now ready for use.

Pressing the scan button a second time will activate the scanner for

normal bar code scanning.

page 1 of 4

Choose

Rent

Phone 1 (800) 622-6484

Fax

1 (866) 937-8254

info@choose2rent.com

www.choose2rent.com

Bottom Side

Table of Contents

Do you have a question about the Linea Pro 6 and is the answer not in the manual?

Page 1 Top Side Dual Purpose Scan Button The Linea Pro 6 uses a single dual-purpose scan button to power on the unit as well as scanning barcodes. When the Linea Pro 5 is left idling for an extended period, the power is automatically turned off to preserve the charge in the internal battery pack.
Page 2 How to Scan To scan a barcode, first activate the Linea Pro 6 by pressing the scan button. Then position the scan head as close to the barcode label as possible so that the scan line crosses both the ends of the barcode (or) is within the width of the red illuminated box.
Page 3 How to Read RFID Cards First activate the Linea Pro 6 by pressing the scan button. Place the RFID tag/card over the receiver/transmitter. Keep the face of the tag/card flat with the receiver/transmitter as close as possible. Please Note: Depending on the type of RFID tags/cards being used, it may be necessary for tags/cards to make direct contact with the surface where the RFID receiver/transmitter is located for proper reading/writing.
Page 4 LED Lighting Indications Result from charging, active/online status, or because of low battery. 1. ALL LED is OFF • Linea Pro 6 is in sleep or ready mode 2. One LED is FLASHING • Lina Pro 6 is charging and syncing 3.