Inserting A Scene From A Vcr – Insert Editing - Sony Handycam DCR-VX2100E Operating Instructions Manual

Inserting a scene from a VCR
– Insert editing
(1) Set the POWER switch to VCR on your
camcorder.
(2) On the VCR, locate a point just before the
insert start point [a], then press X to set the
VCR to the playback pause mode.
(3) On your camcorder, locate the insert end
point [c] by pressing m or M. Then
press X to set it to the playback pause
mode.
(4) Press ZERO SET MEMORY on the Remote
Commander. The ZERO SET MEMORY
indicator flashes and the end point of the
insert is stored in memory. The tape
counter shows "0:00:00." If the tape counter
does not appear, press DISPLAY.
(5) On your camcorder, locate the insert start
point [b] by pressing m, then press z
REC and the button on its right
simultaneously, then immediately press X
on your camcorder.
(6) First press X on the VCR, and after a few
seconds press X on your camcorder to start
inserting the new scene.
Inserting automatically stops near the zero
point on the tape counter. Your camcorder
automatically returns to the recording
pause mode.
4
ZERO SET
MEMORY
5
REC
0:00:00
ZERO SET
MEMORY
PAUSE
(1)
(2)
X
(3)
m M
(4)
(5)
m
z
(6)
X
X
X
X
135