Sony Handycam DCR-VX2100E Operating Instructions Manual page 122

Dubbing only desired scenes
– Digital program editing
Errors in editing
If you connect your camcorder to Sony
equipment with the DV jack, the range of
errors is within +/– 5 frames.
The range may become wider in the following
conditions:
•The interval between CUT-IN and CUT-OUT
is less than five seconds (p. 123).
•CUT-IN or CUT-OUT is set at the beginning
of the tape.
When "ENGAGE REC PAUSE" appears on the
LCD screen or in the viewfinder
Turn the recording VCR to recording pause
mode.
Note
If you start recording from the very beginning
of the tape, the first few seconds of the tape
may not record properly. Be sure to allow
about 10 seconds' lead before starting the
recording.
If the VCR does not operate correctly
Make sure the IR SETUP code is correct; reset
if necessary.
When the operations of the VCR do not
work with an i.LINK cable
Keep the i.LINK connection, and carry out
Preparation 2 (p. 112) again. The audio and
video signals are sent as digital signals.
122