Avaya Scopia XT Series User Manual page 59

Problem
Solution
Solution
Solution
Solution
Solution
Problem
Solution
Problem
Solution
User Guide for Avaya Video Collaboration Solution for IP Office
Version 8.3
The system displays a blank screen.
Verify the power cord of the XT Codec Unit is connected properly at both ends.
Verify the monitor's power cord is connected properly at both ends.
Check that the monitor is connected to HD1
Verify the XT Codec Unit's LED is on. If the LED is blinking, press the Power key
XT Remote Control Unit.
Make sure the XT Codec Unit output is properly connected to the monitor input. Make sure
the monitor/DVI cable is connected properly at both ends.
The screen layout appears to be cropped.
Configure the monitor layout as described below.
Procedure
1. From the endpoint's main menu, select Configure > Quick Setup.
2. Select Next to navigate to the Configure Monitor page.
3. Follow the instructions on the screen to adjust the image.
If necessary, refer to
information.
The system menus or the remote presentation appears to be cropped.
Adjust the way the image appears on the monitor. To see your adjustments in real-time, we
recommend performing this procedure from the endpoint itself.
If configuring from the endpoint, you must first enable advanced configuration, as described
in Deployment Guide for Avaya Scopia
Procedure
1. Access the monitor settings. From the XT Series web interface, select
Administrator settings > I/O connections > Monitor > Graphic Adjustments.
From the endpoint's main menu, select Configure > Advanced > I/O
connections > Monitor > Graphic Adjustments.
2. Navigate to the monitor requiring adjustment (Monitor HD1 or Monitor HD2).
3. Select your preferred image view mode.
and the power is on.
Adjusting the Image Position
®
XT Series.
Troubleshooting the Avaya Scopia
on the
on page 17 for operational
®
XT Series | 59