Step 1 Preparing The Power Supply; Installing The Battery Pack - Sony DCR-IP45E Operating Instructions Manual

Step 1 Preparing the

Installing the battery pack

(1) Lift BATT (battery) RELEASE in the direction
of the arrow to release the battery terminal
cover.
(2) Insert the battery pack in the direction of the
arrow until it clicks.
1
To remove the battery pack
The battery pack is removed in the same way as
the battery terminal cover.
Battery terminal cover
To protect the battery terminals, install the
battery terminal cover after the battery pack is
removed.
Installing the battery pack
Make sure that the battery pack is properly
installed. Check also the battery pack is not
attached to your camcorder askew.
26
power supply
(1)
(2)
2