Sony DCR-IP45E Operating Instructions Manual page 204

Connecting your camcorder to
your computer using the USB
cable – For Windows users
Viewing images recorded on a
"Memory Stick"
(1) Insert a "Memory Stick" into your camcorder.
(2) Connect the AC power adaptor and set the
POWER switch to MEMORY/NETWORK
(DCR-IP55E only).
(3) Connect the
to the USB connector on your computer using
the supplied USB cable.
USB MODE appears on the LCD screen of
your camcorder. Your computer recognises
the camcorder, and the Add Hardware
Wizard starts.
(4) Follow the on-screen messages so that the
Add Hardware Wizard recognises that the
USB drivers have been installed. The Add
Hardware Wizard starts two times because
two different USB drivers are installed. Be
sure to allow the installation to complete
without interrupting it.
You cannot install the USB driver if a
"Memory Stick" is not in your camcorder.
Be sure to insert a "Memory Stick" into your
camcorder before installing the USB driver.
204
(USB) jack on your camcorder
(1)
(2)
(3)
(USB) jack/
USB connector/
USB cable (supplied)/
(4)