Setting Rotor Id; Setting Rpm/Rcf; Setting Run Time -13 - Hanil FLETA 4 Operation Manual

4. Operation

4.5 Setting Rotor Id.

1.Press the Setup/Enter (
2. Press the Left(
▶Rotor Id. setting mode : Rotor flashes on display
3. Press the up(
4. Press the Setup/Enter (
▶ You can check the rotor Id. [7. Rotors]

4.6 Setting RPM/RCF

1.Press the Setup/Enter (
2. Press the Left(
▶RPM setting mode : RPM flashes on display
▶RCF setting mode : RCF flashes on display
3. Press the up(
4. Press the Setup/Enter (
4.7 Setting Run Time
1.Press the Setup/Enter (
2. Press the Left(
▶Min. setting mode : 00' flashes on display
▶Sec. setting mode: 00'' flashes on display
3. Press the up(
4. Press the Setup/Enter (
13 www.ihanil.com
) button.
) or Right( ) button to select rotor Id. mode.
) or down ( ) buttons until the desired rotor id displayed.
) button.
) button.
) or Right( ) button to select RPM mode or RCF mode.
) or down ( ) buttons until the desired RPM/RCF is displayed.
) button.
) button.
) or Right( ) button to select Time mode.
) or down ( ) buttons until the desired run time is displayed.
) button.