Alcatel-Lucent 7210 SAS E OS Quality Of Service Manual page 85

Network Egress QoS Policy Forwarding Class Commands
dot1p-in-profile
Syntax dot1p-in-profile dot1p-priority
no dot1p-in-profile
Context config>qos>network>egress>fc fc-name
Description This command specifies dot1p in-profile mappings.
The no form of the command reverts to the default in-profile dot1p-priority setting for policy-id 1.
Parameters dot1p-priority — This value is a required parameter that specifies the unique IEEE 802.1P value that
dot1p-out-profile
Syntax dot1p-out-profile dot1p-priority
no dot1p-out-profile
Context config>qos>network>egress>fc fc-name
Description
This command specifies dot1p out-profile mappings.
The no form of the command reverts to the default out-profile dot1p-priority setting for policy-id 1.
Parameters dot1p-priority — This value is a required parameter that specifies the unique IEEE 802.1P value that
remarking
Syntax remarking
Context config>qos>network policy-id>egress
Description Remarking is always enabled on the access uplink ports. Since the 7210 SAS E will be used to con-
nect to a particular diffserv domain so it is very important that each and every packet ingressing on
the 7210 SAS E is mapped and marked and thereby assigned to a particular diffserv class while going
through the network. The downstream node, a 7x50 router, will be assigning the FC based on the
Dot1P assigned in 7210 SAS E.
The no form of this command is not supported.
7210 SAS-E OS Quality of Service Guide
will match the Dot1p rule.
A maximum of eight dot1p rules are allowed on a single policy.
Values
0 — 7
will match the dot1p rule.
A maximum of eight dot1p rules are allowed on a single policy.
Values
0 — 7
QoS Commands
Page 85