Alcatel-Lucent 7210 SAS E OS Quality Of Service Manual page 179

Sample Output
*A:card-1>config>qos>access-egress>queue$ show qos access-egress
===============================================================================
Access Egress Policies
===============================================================================
Policy-Id
-------------------------------------------------------------------------------
1
10
30
35
===============================================================================
*A:card-1>config>qos>access-egress>queue$
7210 SAS-E OS Quality of Service Guide
Label
CIR Admin
CIR Rule
PIR Admin
PIR Rule
CBS
Port-Id
Scope
Template
Template
Template
Template
Description (Continued)
Specifies the administrative Committed Information Rate (CIR)
parameters for the queue. The CIR defines the rate at which the system
prioritizes the queue over other queues competing for the same band-
width.
min — The operational CIR for the queue will be equal to or greater
than the administrative rate specified using the rate command except
where the derived operational CIR is greater than the operational PIR.
If the derived operational CIR is greater than the derived operational
PIR, the operational CIR will be made equal to the operational PIR.
max — The operational CIR for the queue will be equal to or less than
the administrative rate specified using the rate command.
closest — The operational PIR for the queue will be the rate closest to
the rate specified using the rate command without exceeding the opera-
tional PIR.
Specifies the administrative Peak Information Rate (PIR) parameters
for the queue. The PIR defines the maximum rate that the queue can
transmit packets through the access port.
min — The operational PIR for the queue will be equal to or greater
than the administrative rate specified using the rate command.
max — The operational PIR for the queue will be equal to or less than
the administrative rate specified using the rate command.
closest — The operational PIR for the queue will be the rate closest to
the rate specified using the rate command.
def — Specifies that the CBS value reserved for the queue.
value — Specifies the value to override the default reserved buffers for
the queue.
Specifies the physical port identifier that associates the access egress
QoS policy.
Description
Default Access egress QoS policy.
QoS Commands
Page 179