Alcatel-Lucent 7210 SAS E OS Quality Of Service Manual page 173

configured the FC-Dot1p map the marking of packets is still done according to
Access Egress Policy ID 1 Definition, on page
using these commands.
The no form of the command sets the IEEE 802.1P or IEEE 802.1Q priority bits to default FC-Dot1P
marking map as listed in
Default
Dot1P values marked by default.
dot1p-value — This value specifies the unique IEEE 802.1P value that will match the dot1p rule. If
dot1p-out-profile
Syntax dot1p-out-profile dot1p-value
no dot1p-out-profile
Context config>qos>access-egress>fc
Description This command explicitly defines the egress IEEE 802.1P (dot1p) bits marking for fc-name. All pack-
ets belonging to a particular FC that have either an IEEE 802.1Q or IEEE 802.1P encapsulation use
the explicitly defined dot1p-value. If the egress packets for fc-name are not IEEE 802.1Q or IEEE
802.1P encapsulated, the dot1p command has no effect. The dot1p-in-profile dot1p-value and
dot1p-out-profile dot1p-value commands will provide the capability to mark Dot1p on an egress
access port for the in and out of profile packets. Remarking of Dot1P bits is always enabled. If the
user has not explicitly configured this FC-Dot1p map the marking of packets is according to FC-
Dot1P marking table as listed in
User can explicitly define the new Dot1P values using these commands.
The no form of the command sets the IEEE 802.1P or IEEE 802.1Q priority bits to default FC-Dot1P
marking map as listed in
Parameters
dot1p-value — This value specifies the unique IEEE 802.1P value that will match the dot1p rule. If
7210 SAS-E OS Quality of Service Guide
Table 14, Default Access Egress Policy ID 1 Definition, on page
the command is executed multiple times with the same dot1p-value, the previous forwarding
class and enqueuing priority is completely overridden by the new parameters or defined to be
inherited when a forwarding class or enqueuing priority parameter is missing.
A maximum of eight dot1p rules are allowed on a single policy.
Values
0 — 7
Table 14, Default Access Egress Policy ID 1 Definition, on page
the command is executed multiple times with the same dot1p-value, the previous forwarding
class and enqueuing priority is completely overridden by the new parameters or defined to be
inherited when a forwarding class or enqueuing priority parameter is missing.
A maximum of eight dot1p rules are allowed on a single policy.
Values
0 — 7
41. User can explicitly define the new Dot1P values
Table 14, Default Access Egress Policy ID 1 Definition, on page
QoS Commands
Table 14, Default
41.
41.
41.
Page 173