Flashforge Creator3 User Manual page 67

Method 2：Connect Via WiFi
①Connect Creator3 with your PC under AP mode
a.Turn on your Creator3
b. Tap [Tools]-[Setting]-[WLan hotspot]-[WLan hotspot
c. Click on the wireless network setting in your computer, and find the wireless
signal-"Creator3". Click
hotspot.
d. Click [Print]-[Connect Machine]
box pops up. You need to select "Wi-Fi" in Connect Mode. Enter into the IP Address
shown on the interface and then click [Connect].
Creator3 User Guide | www.flashforge.com
[Connect]
to connect your computer with Creator3 via Wlan
on FlashPrint. Then the following dialog
67
ON].
400-699-1063