File Menus - Flashforge Creator3 User Manual

filament at a certain point.
6-14
(6-14) Click [Edit], then you can add or remove a height.

6.2.12 File Menus

①New Project
[File]--[New Project]
Click can build a blank project. If there is an unsaved
modification on previous project, then it will inform you whether the modification
needs to be saved or not. Click [Yes] will save the modification, while click [No] will
abandon it. If click [Cancel] or close tool tip, then will cancel the new project.
②Saving
After finishing the model edit and adjustment, there are two ways below to save all
models in the scene.
Method 1:
[File]--[Save Project]
Click in the menu bar to save the file as a project file with the
".fpp" suffix, all models in the scene (include support) are independent. After
Creator3 User Guide | www.flashforge.com 400-699-1063
63