Print From Computer (Wifi Connection) - Flashforge Creator3 User Manual

7.2.2 Print from Computer (WiFi connection)

① Connect your Creator3 with your PC via WiFi.
Enter into the IP Address shown on your Creator3 interface and then click [Connect].
② Turn on your Creator3, level the build plate and load the filament.
③ Click [Print]
transference, the printer will heat up automatically. And when heating finishes, the
printer will start to build the model.
If you want to print a Gcode from a local folder, you just need to load the file into
FlashPrint at the status of Ethernet connection or WiFi connection, then click the
[Print] button on the top-right.
● Load the target Gcode file into FlashPrint.
Creator3 User Guide | www.flashforge.com
and transfer your Gcode file to your Creator3. After completing
74
400-699-1063