Scale; Cut - Flashforge Creator3 User Manual

6.2.7

Scale

Select the target object and scale the object by the following two methods:
Method 1: Click the
scale the model. The corresponding values will display near the object.
Method 2: Click the
axes positioning. Click the
[Reset]
Click to reset the size of model.
Note: If the [Uniform Scaling]
proportion when changing
only change the value of the corresponding positioning.
6.2.8

Cut

Left-click on the model to select it and double-click on the
plane. The direction and position are available for setting.
①Draw with Mouse
②X Plane
Creator3 User Guide | www.flashforge.com
[Scale] icon on the left, hold down the left mouse button and
[Scale]
icon on the left and then enter into scale values in X/Y/Z
[Maximum] button to get largest size possible for building.
radio button is clicked, it will scale the model in equal
value in any positioning of the model. Otherwise it will
[Cut]
55
icon to set the cut
400-699-1063