Setting - Flashforge Creator3 User Manual

1
2
3
4
5
6
7
8
9
10
11
12
Creator3 User Guide | www.flashforge.com

Setting

To implement relevant function setups.
Tap [Setting] to enter the setting interface:
1. Language: To set the display language
2. WiFi: To turn on/off the WiFi
3. WLan hotspot: To turn on/off the WLan
hotspot.
4. Door Opened Pause:To turn on/off the
Door Opened Pause.
5. Door Opened Detector:To turn on/off the
Door Opened Detector.
6. Startup Sound: To turn on/off the Startup
Sound.
7. Left Filament Check: To turn on/off the
filament check on left extruder.
8. Right Filament Check: To turn on/off the
filament check on right extruder.
9. Calibration: To adjust the initial distance
between the extruder and the build plate.
10. Light Bar Control: To turn on/off the
light bar control.
11. Factory Reset: Return to factory setting.
12. Update: To update the firmware version.
23
400-699-1063