8.4.2
Replace SSD
Requirements
● The device is disconnected from the power supply.
● The device is open, see the section "Opening and closing the backplane cover
(Page 75)".
● An SSD is installed in the backplane cover.
● T10 screwdriver
Procedure
1. Pull out the connectors
Take into account the safety latch of the
cable in doing so.
2. Set the backplane cover down flat.
3. Remove the indicated screws and firmly
hold down the cover
supply.
4. Remove the drive cage with the SSD and
power supply and place it with the back
facing up.
SIMATIC IPC477E PRO
Operating Instructions, 08/2017, A5E39912462-AA
①
②
③
,
and
.
④
of the power
Maintaining and repairing the device
8.4 Installing and removing hardware
89