Siemens SIMATIC IPC477E PRO Operating Instructions Manual page 39

Procedure
The following description shows an example of how to attach the PRO device to a support
arm system using the optionally available Siemens flange mount
round tube
NOTICE
Observe the torques
If you apply too much torque to tighten the screws of the backplane cover and the terminal
compartment cover or the screws for fastening the device to a support arm or pedestal, the
threads of the enclosure, intermediate plate or support arm may be damaged.
If you tighten the screws with a torque that is too low, the device is not sealed.
1. Remove the screws
2. Open the terminal compartment cover and set it aside safely.
⑤
⑥
⑦
⑧
⑨
SIMATIC IPC477E PRO
Operating Instructions, 08/2017, A5E39912462-AA
⑧
that fits the opening of the PRO device is performed in a similar fashion.
⑤
of the terminal compartment cover.
Screws for terminal compartment cover
Setscrews
Flange mount (not included in the product package; see System components (Page 15))
Third-party round tube (∅ 48 mm)
Cover plate (Included in the product package; see Accessory kit (Page 14))
Mounting and connecting the HMI device
4.3 Mounting the device
⑦
. Mounting to a 48.3 mm
39