Siemens SIMATIC IPC477E PRO Operating Instructions Manual page 77

5. Open the backplane cover
enclosure, as shown below.
6. Now you can install and remove the hardware.
SIMATIC IPC477E PRO
Operating Instructions, 08/2017, A5E39912462-AA
NOTICE
Damage to the device
②
An SSD and power supply
the motherboard with short cables
completely or set it aside, you pull on the cables by their connectors. The device may be
damaged.
1. Secure the backplane cover
2. Pull out the cable connector
3. Unplug the power supply connector
Expanding the device and assigning the device parameters
7.1 Opening and closing the backplane cover
①
, gently open it 90° upwards and place it on the edge of the
④
are built into the backplane cover and connected to
③
. If you open up the backplane cover
⑤
from falling down.
③
(see section "Replace SSD (Page 89)").
①
on the motherboard.
⑤
77