Ssd Slider Configuration - Siemens SIMATIC IPC BX-56A Operating Instructions Manual

Configuring firmware
3.4 "Advanced" tab
Firmware Value
setting
PCIe Max Link
Speed
Detect Timeout [Number]
3.4.12

"SSD Slider Configuration"

Calling "SSD Slider Configuration"
This configuration is only available for SIMATIC IPC BX-59A.
Select: "Setup Utility (Page 10)" > "Advanced" > "SSD Slider Configuration".
Firmware setting
Slider Port 1
(X52)
NVMe (BUS:xx Present/Not
Device:xx
Function:xx)
NVMe Max Link
Speed
Slider Port 2
(X53)
Serial ATA Port [Empty]/[Drive
(X53)
Software SUPPORTED/Unkn
Preserve
NVMe (BUS:xx Present/Not
Device:xx
Function:xx)
NVMe Max Link
Speed
20
Setting in
delivery state
Auto x
Gen1
Gen2
Gen3
0
Value Setting in
delivery state
BX-59A
Enabled x
Disabled
Present
Auto x
Gen1
Gen2
Gen3
Gen4
Enabled x
Disabled
name]
own
Present
Auto x
Gen1
Gen2
Gen3
Gen4
x Maximum possible link speed.
The link speed is limited to GEN 1.
The link speed is limited to GEN 2.
The link speed is limited to GEN 3.
0 The number of milliseconds reference code will wait for link to
exit Detect state for enabled ports before assuming there is no
device and potentially disabling the port.
The input range is from 0 to 65535.
Enable Slider Port.
Disable Slider Port.
The NVMe bus device function is present or not.
Configure PCIe Speed.
Enable Slider Port.
Disable Slider Port.
The NVMe bus device function is present or not.
Configure PCIe Speed.
Firmware/BIOS description (SIMATIC IPC BX-56A, IPC BX-59A)
Meaning
Meaning
Operating Instructions, 10/2023, A5E52427534-AA