Class I Locations; Class Ii Locations - Xycom 3500 Series Manual

3500 Series Flat Panel Industrial PC
Do not disconnect equipment unless the power has been switched off or
the area is known to be non-hazardous.
Avant de deconnecter l'equipment, coupler le courant ou s'assurer que
l'emplacement est designe non dangereux.
When in hazardous locations, turn off power before replacing or wiring
modules.
Dans les situations hasardees, couper la courant avant de remplacer ou
de cabler les modules.
To maintain a safe condition, do not use an external keyboard or mouse or
USB port devices when the unit is operating in a hazardous environment.
Definitions
The following Class and Division explanations are derived from Article 500 (Sections 5
and 6) of the United States National Fire Protection Agency National Electric Code
(NFPA 70, 1990). They are not complete and are included here only for a general de-
scription for those not familiar with generic hazardous locations' requirements.
Persons responsible for the installation of this equipment in Hazardous Locations are re-
sponsible for ensuring that all relevant codes and regulations related to location rating,
enclosure, and wiring are met.

Class I Locations

Class I locations are those in which flammable gases or vapors are or may be present in
the air in quantities sufficient to produce explosive or ignitable mixtures.

Class II Locations

Class II locations are those that are, or may become, hazardous because of the presence
of combustible dust.
44
Warning - Explosion Hazard
Advertissement Risque D' Explosion
Warning - Explosion Hazard
Advertissement Risque D' Explosion
Warning