Xycom 3500 Series Manual page 30

3500 Series Flat Panel Industrial PC
Touchscreen Drivers
Depending upon the date of purchase, the Xycom Automation unit will have one of two
possible touchscreen controllers:
These controllers function similarly. However, the following sections require attention to
the type of controller installed.
Microtouch Controller
If the touchscreen is factory-installed, you will receive a disk with MS-
DOS and Windows 95 touchscreen drivers. If Windows 95 or Windows
NT is factory-installed, the touchscreen drivers are provided. If you
change the operating system, you must install the corresponding touch-
screen driver software. Refer to the touchscreen manual for instructions.
Xycom Controller
If the touchscreen is factory-installed, you will receive a CD with MS-
DOS and Windows touchscreen drivers. If Windows is factory-installed,
the touchscreen drivers are provided. If you change the operating system,
you must install the corresponding touchscreen driver software. Refer to
the touchscreen manual for instructions.
CD-ROM Drivers
A CD-ROM driver disk comes with the CD-ROM option, as well as the preinstalled
driver for the operating system you have selected. If you change operating systems and
need help loading the required CD-ROM driver, contact Xycom Automation technical
support at 1-800-289-9266 x450.
If you need to reinstall Windows NT, you must have an internal CD-
ROM drive or an external parallel port CD-ROM drive as Windows NT
only ships on a CD-ROM disk.
30
•
The Microtouch Controller P/N 114084
•
The Xycom Controller
If the Windows or Windows NT operat-
ing system is factory installed, then
touchscreen is set up on COM2, making
this port unavailable.
P/N 140554
Note
Note