Assembly - Grizzly G0886 Owner's Manual

Assembly

The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
With the exception of the proximity sensor, drip
tray, and cutoff chute, the Model G0886 comes
fully assembled from the factory.
To assemble machine:
1.
Slide proximity sensor bar into hole in fixed
vise jaw with flat edge on bar upward, as
shown in Figure 14, then tighten set screws.
Fixed
Vise Jaw
Flat
Edge
Proximity Sensor Bar
Figure 14. Proximity sensor bar attached.
2.
Slide proximity sensor bracket assembly onto
proximity sensor bar, as shown in Figure 15,
then tighten adjustable handle.
Proximity
Sensor Bar
Figure 15. Proximity sensor bracket attached.
-20-
Set
Screw
Set Screw
Proximity Sensor
Bracket Assembly
Adjustable
Handle
3. Attach proximity sensor to proximity sensor
bracket assembly with pre-installed knob
bolt, as shown in Figure 16.
Sensor Bracket
Proximity
Sensor
Knob Bolt
Figure 16. Proximity sensor attached.
4.
Position cutoff chute between vise table and
angled base flange, as shown in Figure 17.
Vise Table
Angled Base
Flange
Figure 17. Cutoff chute positioned.
5. Position drip tray on base edge, as shown in
Figure 18.
Figure 18. Drip tray positioned.
Model G0886 (Mfd. Since 01/19)
Proximity
Assembly
Cutoff
Chute
Drip Tray
Base Edge