Grizzly G0886 Owner's Manual page 59

Adjusting Roller Bearings
1. Complete Adjusting Carbide Blade Guides
procedure.
2.
DISCONNECT MACHINE FROM POWER!
3.
On left blade guide, loosen hex nut on front
eccentric shaft (see Figure 84).
4.
Turn eccentric shaft and adjust roller bearing
(see Figure 84) so it lightly contacts blade or
has maximum clearance of 0.002".
Note: Since bearings twist blade into posi-
tion, it is acceptable if there is 0.001"-0.002"
gap between blade and front or back of bear-
ing. Just make sure not to squeeze blade too
tightly with bearings. After guide bearings
are set, you should be able to rotate guide
bearings (although they will be stiff) with your
fingers.
Model G0886 (Mfd. Since 01/19)
Eccentric
Shaft (Rear)
Hex Nut
Roller Bearing
(Rear)
Figure 84. Location of roller bearings.
5.
While holding eccentric shaft in place, tighten
hex nut to secure setting.
6. Repeat Steps 3–4 on rear eccentric shaft.
7. Repeat Steps 3–6 on right blade guard.
Eccentric
Shaft (Front)
Hex Nut
Roller Bearing
(Front)
-57-