Controls & Components - Grizzly G0886 Owner's Manual

Controls &
Components
To reduce your risk of
serious injury, read this
entire
using machine.
Refer to the following figures and descriptions to
become familiar with the basic controls and com-
ponents of this machine. Understanding these
items and how they work will help you understand
the rest of the manual and minimize your risk of
injury when operating this machine.
Control Panel
C
A B
J
L
M
I
K
Figure 1. Model G0886 control panel.
Figure 2. Master power switch location.
A. Hydraulic Pump Button
lic pump ON. Must be pressed for other
bandsaw controls to function.
-4-
manual BEFORE
D E
G
F
H
N
: Turns hydrau-
B. Power Lamp: Illuminates when master power
switch is turned ON.
C. Emergency Stop Button: Stops all machine
functions. Twist clockwise to reset.
D. Feed System Button
ON when machine is in Manual operation
mode.
E. Blade Start Button
ON and starts saw blade. For button to work,
hydraulic pump button (A) must be pressed,
headstock must be raised, and vise close
button (K) must be pressed.
F. Blade Feed Rate Dial: Controls rate at which
blade feeds into workpiece.
G. Operation Mode Switch: Selects between
Auto or Manual
H. Feed Roller Switch: Turns feed motor OFF
and ON when FWD
FWD must be selected for Auto operation
mode.
I. Vise Open Button
vise to release workpiece after cut(s).
J. Lower Headstock Button
lowers headstock at rate determined by blade
feed rate dial (F). Continues lowering blade
until lower limit switch is activated or button
is released.
K. Vise Close Button
vise to lock workpiece during cut(s). Button
must be pressed for blade start button (E) to
function.
L. Raise Headstock Button
raises headstock. Continues raising blade
until upper limit switch is activated or button
is released.
M. Digital Counter: Sets number of consecutive
cuts machine will perform. The number of
completed cuts is displayed. Push RESET to
clear display and reset counter.
N. Master Power ON/OFF Switch: Turns
incoming power ON and OFF.
Model G0886 (Mfd. Since 01/19)
: Turns feed motor
: Turns main motor
operation mode.
or REV are selected.
: Hydraulically opens
: Hydraulically
: Hydraulically closes
: Hydraulically