Table of Contents
Advertisement
Using the 9847V Pulse Oximeter
Calendar and Clock Settings
Calendar Settings
NOTE: Setting the month to "00" disables the calendar and clock functions. The calendar and
clock functions are used to time stamp real-time data for memory. Unless you intend to use real-
time data output or memory playback options, skip this section.
1. After the calendar setting has been selected in the setup mode, "y" appears in the SpO
display indicating the calendar setup mode for the year. The year may be set to 00
through 99.
2. After selecting the year, the display shows "nn," indicating the setup mode for the month. The
month may be set to 00 through
3. After selecting the month, the display will show "d," indicating the setup mode for the day of
the month. The day may be set to 01 through 31.
4. After selecting the day, the setup mode continues to the clock settings.
Clock Settings
1. After the calendar settings have been selected in the setup mode, "h" appears in the SpO
display indicating clock setup mode for the hour. The hour may be set to 00 through 23.
2. After selecting the hour, the SpO
The minutes may be set to 00 through 59.
3. After selecting the minutes, the device will:
a. Exit setup mode.
b. Briefly display rCL ALr (recall alarm settings) and then the current alarm limit settings.
c. Begin normal operation.
Visible Indicators
Refer to Figure 2 on page 7 for a detailed illustration of the 9847V controls and indicators.
The intended operator's position for correctly perceiving a visual alarm signal and its priority is 1 meter
(3.3 feet), per IEC 60601-1-8.
SpO
Display
2
The SpO
display is the upper numeric display. This 3-digit light-emitting diode (LED)
2
display shows the current oxygen saturation percentage.
Pulse Rate Display
The pulse rate display is the lower numeric display. This 3-digit LED display shows pulse
rate in pulses per minute.
12
.
display shows "nn," indicating the setup mode for minutes.
2
2
2
%SpO 2
8
8
8
8
8
8
23
Advertisement
Table of Contents
