Setting Parameters; Alarm Mode Setting - Nonin 9847V Operator's Manual

Using the 9847V Pulse Oximeter
Disabling the Audible Alarms During Power On
1. With the unit in Standby, press and hold Audible Alarm Disable while pressing and then
releasing On/Standby.
2. Release Audible Alarm Disable when 888 888 displays on the SpO
displays.
3. After the power on self-test, the Audible Alarm Disabled indicator is steadily lit. The animal
alarms are set at the default limits.
4. The audible alarms can be re-enabled by pressing Audible Alarm Disable again.

Setting Parameters

NOTE: The Advance button sets your selection. The Alarm Limits button moves you to the next
setting.
NOTE: See page 20 for Table 2 - Alarm Limit, Breath Beep Pitch, Calendar, and Clock Mode
Parameters.

Alarm Mode Setting

WARNING: Verify all alarm settings and limits during system startup to ensure that
they are set as intended.
CAUTION: Review all limits to ensure they are appropriate for the patient.
!
CAUTION: Setting alarm limits to extremes can render the alarm system useless.
!
1. Upon entering setup mode, "ALr" appears in the SpO
alarm mode may be set to dFt, rCL, or C02:
• dFt (default limits) sets up the system-defined (default) animal alarm limit settings.
• rCL (recall stored limits) sets up the last stored animal alarm limit settings of the 9847V.
• C02 (no breath alarm limits and sensor alarms) temporarily disables the oxygen saturation high
and low settings and the pulse rate high and low settings by setting them to 0FF. Only the no
breath alarm and the sensor alarms are enabled, along with the breath beep pitch mode
selection. Setup mode skips over the other animal alarm settings (i.e., C02 alarm mode first
goes to nbd, then to FPt, etc.).
2. When the alarm mode setting has been selected, setup mode continues to the no breath
delay time setting.
and pulse rate
2
display indicating alarm mode. The
2
21