Setting Up The Tabletop Stand; Figure 5. Setting Up The Model 8500Ts Tabletop Stand - Nonin 9847V Operator's Manual

Introduction

Setting Up the Tabletop Stand

The Model 8500TS Tabletop Stand can be used to place the Model 9847V in a viewable position. Slide
the Model 9847V into the stand, then swing the metal leg into position behind the stand to form a solid
base. Route the Model UNI-EXT-3 Extension Cable or the pulse oximeter sensor cable through the
notch at the bottom edge of the stand (figure 5).
.
Route the cable through the notch
Figure 5: Setting Up the Model 8500TS Tabletop Stand
Additional hardware is available for mounting the Model 8500TS on the wall or in a pole mount
configuration. See "Accessories" on page 42 for more information.
13