Switching The Cabinet To Off Mode; Setting The Time - Thermo Scientific Safe 2020 Operating Instructions Manual

6. Handling and control
2. To deactivate the contact:
Press, then release the
The yellow status display
NOTE – LED for potential-free contact
If this button is pressed on the operating panel,
the LED also illuminates if no external alarm
system is connected to the device.
6.3.8

Switching the cabinet to OFF mode

The unit can be switched to OFF mode from any other operating mode:
• Keep the
6.3.9

Setting the time

The current time of the time zone in which the unit operates must be set at the
start-up of the safety cabinet. Two different display modes can be selected:
• CET mode (24:00 hours)
• AM/PM mode (12:00 hours)
When the time is to be set, the device must be in the OFF mode.
1. Set the time:
Keep the
The minute display shows either A, P or no value (CET time display).
The time zone is set at the same time as the hour value: First, set
the time zone (sequence: CET, A, P), then set the exact hour value.
2. While increasing or decreasing the hour value in increments, set the
time zone:
Press, then release the
3. Scroll through values:
Keep the
If the keys are depressed for approx. 2 or 3 seconds, a higher scroll
speed is selected.
4. Store the hour and time zone setting:
Press the
The function switches to minute display (flashing).
key
goes off.
key depressed until the ready signal sounds
key depressed until the two-digit hour disply flashes.
or the
or the key depressed
key
Operating Instructions Safety Cabinet Safe 2020 / Maxisafe 2020
key
41