System Memory Configuration; Install Memory; Upgrade Memory - Shuttle FN41 Manual

3.3 System Memory Configuration

The FN41 mainboard has two 184-pin DIMM slots that allow you to install
from 64MB up to 2GB of system memory.
Each 184-pin DIMM (Dual In-line Memory Module) Slot can accommodate
64MB, 128MB, 256MB, 512MB, 1G of DDR200, DDR266, DDR333, and
DDR400 compliant 2.5V single (1 Bank) or double (2 Bank) side 64-bit wide
data path DDR SDRAM modules.

Install Memory:

Install memory in any or all of the slots and in any combination shown as
follows.
DIMM Socket
DIMM 1
DIMM 2
Note: Maximum installed memory is 2GB.
Note: You do not need to set any jumper to configure memory since the
BIOS utility can detect the system memory automatically. You can
check the total system memory value in the BIOS Standard CMOS
Setup menu.

Upgrade Memory:

You can easily upgrade the system memory by inserting additional DDR
SDRAM modules in available DIMM slots. The total system memory is calcu-
lated by simply adding up the memory in all DIMM slots. After upgrade, the
new system memory value will automatically be computed and displayed in
the field " Standard CMOS Setup" of BIOS setup program.
Memory Modules
,
64MB, 128MB, 256MB
184-pin 2.5V DDR SDRAM DIMM
,
64MB, 128MB, 256MB
184-pin 2.5V DDR SDRAM DIMM
- 39 -
512M , and 1G
512M , and 1G
Module
Quantity
x 1
x 1