Shuttle FN41 Manual page 63

Power On Function
Enable you to set power on paramenters. The default setting enables
you to use a hot key to turn on the system.
Ø The Choice: Password, Hot Key, Mouse Move, Mouse Click, Any
Key, BUTTON ONLY, or Keyboard 98.
K/B Power On Password
When the POWER ON Function is set to Password, use this item to set
the password.
Ø The Choice: Enter.
Hot Key Power On
When ths POWER ON Function is set to Hot Key, use this item to set
the hot key combination that turns on the system.
Ø The Choice: Control -F1~Control- F12.
Onboard FDC Controller
This item specifices onboard floopy disk drive controller. This setting
allows you to connect your floopy disk drives to the onboard floopy
connector.
Ø The Choice: Enable or Disabled.
Onboard Serial Port1
This option is used to assign the I/O address and interrupt request(IRQ)
for the onboard serial port1(COM1).
Ø The Choice: Disabled, 3F8-IRQ4, 2F8-IRQ3, 3E8-IRQ4, 2E8-IRQ3,
or Auto.
Onboard Infrared Port
This option is used to assign the I/O address and interrupt request(IRQ)
for the onboard infrared port.
Ø The Choice: Disabled, 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ, 3E8/IRQ3, or
Auto.
UART Mode Select
This item allows you to select IrDA infrared through COM2 port.
Ø The Choice: IrDA, ASKIR, or SCR
UR2 Duplex Mode
This item allows you to select the IR half or full duplex function.
Ø The Choice: Full, or Half.
- 60 -