Socket Bluetooth iPAQ User Manual page 9

The LED and beep behaviors below are for the Bluetooth CHS v2.
Status Indicator LED
LED LED Activity
1 blink per second
Bluetooth
Status
1 blink per 3 seconds
(Blue)
Good Read
On
(Green)
Blinking
Battery
Status
Off
(Red)
Status Indicator Beeps
Beep Pattern
2 beeps (low-high)
2 beeps (high-low)
1 beep
2 beeps
(same tone)
2 long beeps
(same tone) with
Permanent Pairing
enabled
1 beep with green
LED (optional
setting)
Touch Screen Stylus
The Socket Bluetooth CHS features a stylus tip in the tail
of the Bluetooth CHS that you can use on Pocket PC and
other device touch screens.
WARNING: Do not use the stylus if damaged. A
damaged stylus may scratch the display screen of
your computer.
Note: The stylus does not work with tablets using Active Matrix displays.
CHAPTER 1: INTRODUCTION
Bluetooth radio is on, but not connected.
Scanner connected to computer
Data successfully scanned and transmitted
to host device.
20% battery capacity remaining
Off or Good Battery status
Power on
Power off
Scanner connected to computer
Scanner disconnected from computer
Scanner unsuccessfully tried 20 times to connect to the
device assigned as its Permanent Pair
Data successfully scanned and sent to computer
Meaning
Meaning
9