Socket Bluetooth iPAQ User Manual page 16

STEP 3: T
URN ON THE
Press and hold the small power button for 3 seconds, until the LED turns
blue and the scanner beeps twice (low-high). The LED should blink blue once
per second to show that the Bluetooth radio is on but not connected.
After the scanner is turned on, its Bluetooth mode will change over time if no
connection is made.
Note: This Bluetooth mode sequence is for the Bluetooth CHS v2.
Time after turning on scanner
0-5 minutes
5-20 minutes
20 minutes
STEP 4: S B
TART
Note: Refer to your Bluetooth hardware/software documentation for full
instructions.
1. If using an add-on Bluetooth card or adapter, such as the Socket Scanning
Companion USB adapter, plug it into your computer.
2. Start your computer's Bluetooth software. For some computers, the Bluetooth
software will automatically launch after you turn on the Bluetooth radio.
3. Turn on the Bluetooth radio. For some computers, the Bluetooth radio must be
enabled through the software. Other computers have a hardware switch.
Note: Your Bluetooth software may vary from the screen shown.
16
B
LUETOOTH
Bluetooth mode
Discoverable and connectable
Connectable
Scanner automatically powers off
Y
LUETOOTH ON OUR
CHS
C
OMPUTER