HP ProCurve 9304M Security Manual page 83

Configuring Maximum Idle Time for SSH Sessions
By default, SSH sessions do not time out. Optionally, you can set the amount of time an SSH session can be
inactive before the HP device closes it. For example, to set the maximum idle time for SSH sessions to 30
minutes:
ProCurveRS(config)# ip ssh idle-time 30
Syntax: ip ssh idle-time <minutes>
If an established SSH session has no activity for the specified number of minutes, the HP device closes it. An idle
time of 0 minutes (the default value) means that SSH sessions never timeout. The maximum idle time for SSH
sessions is 240 minutes.
Displaying SSH Connection Information
Up to five SSH connections can be active on the HP device. To display information about SSH connections, enter
the following command:
ProCurveRS# show ip ssh
Connection Version
1
2
3
4
5
Syntax: show ip ssh
This display shows the following information about the active SSH connections:.
This Field...
Connection
Version
Encryption
June 2005
Encryption
1.5 ARCFOUR
1.5 IDEA
1.5 3DES
1.5 none
1.5 none
Table 3.1: SSH Connection Information
Displays...
The SSH connection ID. This can be from 1 – 5.
The SSH version number. This should always be 1.5.
The encryption method used for the connection. This can be IDEA,
ARCFOUR, DES, 3DES, or BLOWFISH.
State Username
0x82 neville
0x82 lynval
0x82 terry
0x00
0x00
Configuring Secure Shell
3 - 9