HP ProCurve 9304M Security Manual page 113

Table 4.6: Output from the show dot1x mac-session command (Continued)
This Field...
Auth-State
Age
CAM Index
Displaying Information About the Ports in an 802.1X Multiple-Host Configuration
To display information about the ports in an 802.1X multiple-host configuration, enter the following command:
ProCurveRS# show dot1x mac-session brief
Port Number of
----------------------------------------------------------
1
3
Syntax: show dot1x mac-session brief
The following table describes the information displayed by the show dot1x mac-session brief command.
Table 4.7: Output from the show dot1x mac-session brief command
This Field...
Port
Number of users
Number of Authorized users
Dynamic VLAN
Dynamic Filters
June 2005
Displays...
The authentication state of the dot1x-mac-session. This can be one
of the following:
permit – The Client has been successfully authenticated, and traffic
from the Client is being forwarded normally.
blocked – Authentication failed for the Client, and traffic from the Client
is being dropped in hardware.
restricted – Authentication failed for the Client, but traffic from the
Client is allowed in the restricted VLAN only.
init - The Client is in is in the process of 802.1X authentication, or has
not started the authentication process.
The software age of the dot1x-mac-session.
If the MAC address is blocked, the index entry for the Layer 2 CAM
entry created for this MAC address. If the MAC address is not
blocked, either through successful authentication or through being
placed in the restricted VLAN, then "N/A" is displayed. If the hardware
aging period has expired, then "ffff" is displayed for the MAC address
during the software aging period.
Number of
users Authorized users
0 0
2 2
Displays...
Information about the users connected to each port.
The number of users connected to the port.
The number of users connected to the port that have been
successfully authenticated.
Whether the port is a member of a RADIUS-specified VLAN.
Whether RADIUS-specified IP ACLs or MAC address filters have
been applied to the port.
Configuring 802.1X Port Security
Dynamic Dynamic
VLAN Filters
no no
yes no
4 - 27