Positioning Control Program Examples - Mitsubishi Q Series User Manual

7 SEQUENCE PROGRAM USED FOR POSITIONING CONTROL

7.4 Positioning control program examples

No.1 Parameter setting program
No.2 OPR data setting program
7 - 8
An example of the "Axis 1" positioning control program is given in this section.
[No.1] to [No.3] parameter and data setting program
When setting the parameters or data with the sequence program, set them in the QD70 using the
TO command from the PLC CPU. (Carry out the settings while the PLC READY signal [Y0] is OFF.)
When setting the parameters or data with the GX Configurator-PT, the [No.1] to [No.3]
program is not necessary.
MELSEC-Q
7 - 8