Creating A Program; General Configuration Of Program - Mitsubishi Q Series User Manual

7 SEQUENCE PROGRAM USED FOR POSITIONING CONTROL

7.3 Creating a program

7.3.1 General configuration of program

7 - 5
This section explains "positioning control operation programs" actually used. The
programs designed to perform the functions described in "SECTION 2 CONTROL
DETAILS AND SETTING" are installed in the "positioning control operation programs"
explained in "Section 7.3.2". (To monitor control, add a necessary monitor program
according to the system. Refer to "Section 4.6 List of monitor data" for monitor items.)
The general configuration of the "positioning control operation program" is shown
below.
Start of program creation
Parameter and
data are...
Set using the
GX Configurator-PT
Initialization program
Start method setting program
Start program
JOG operation program
Sub program
Stop program
Completion of program
creation
Set using the
sequence program
Parameter and data
setting program
Refer to section 7.5.1
Refer to section 7.5.2
Refer to section 7.5.3
Refer to section 5.7
Refer to section 7.5.4
MELSEC-Q
7 - 5