Mounting The Black Developing Assembly - Canon iR C6800 Series Installation Procedure

Chapter 1
[2]
F-1-55
16) Fix the torque limiter in place using a screw [1].
[1]
F-1-56
If you fail to release the torque limiter, you will
not be able to mount the locking plate of the black
developing assembly. Be sure not to leave out the
work.
1.2.8 Mounting the Black
Developing Assembly
iR C6800C / iR C6800CN / iR 5800C / iR 5800CN
If you must touch a black developing assembly, be
sure that your hands are free of foreign matter
(especially of metal) before dong so. (Adhesion of
foreign matter on the cylinder is likely to cause image
faults.)
1) Remove the 2 screws [1], and detach the joint plate
[2].
18
[1]
[2]
0002-6683
[1]
F-1-57
2) Hold the black developing assembly in lengthwise
direction, and take it out of its package box.
- The machine's black developing assembly is
equipped with a potential sensor. Do not touch the
detection widow [1] of the sensor.
- Do not subject the black developing assembly to
impact to prevent damage to the potential sensor as by
dropping it.
- Be sure to place paper before placing the black
developing assembly on the floor or a table.
F-1-58
3) Turn the developing cylinder gear [1] by hand to
check for scratches on the cylinder.
Do not touch the area [2] of the developing
cylinder cover indicated in the diagram; otherwise, the
blade can leave its trace on the cylinder.
[2]
[1]