Chapter 1
[2]
[1]
F-1-73
7) Connect the connector [1] coming from the black
developing assembly.
[1]
F-1-74
8) Secure the process unit [1] in place using 3 binding
screws (M4x8).
[2]
F-1-75
Be sure to use the binding screws. The use of RS
tightening screws in the area of aluminum die-casting
can damage the threads of the screws.
22
[2]
[2]
[1]
9) Fit the drum fixing member [2] to the drum flange
[1]; then, hold it in place using the drum stop tool.
Thereafter, tighten the drum fixing screw [4] using a
screwdriver.
Be sure to fix the protrusion [5] of the drum stop
tool in place with a screw while matching it against
the notch [6] of the drum flange.
[2]
[4]
[3]
[5]
F-1-76
1. If the photosensitive drum is let to turn clockwise
during the work, the scoop-up sheet can become
soiled to cause stray toner. Be sure to hold the drum
stop tool firmly in place when tightening the drum
fixing screw.
2. Check to be sure that the protrusion of the drum
fixing member is between he markings [1] "." and ".."
of the drum flange.
[1]
[6]