Canon iR C6800 Series Installation Procedure page 60

Chapter 1
[1] [2]
F-1-162
9) Route the harness [1] of the key switch through the
wire saddle [2].
F-1-163
10) Connect the connector [1] of the key switch.
F-1-164
11) Fix the plate (key switch) [1] in place using the 2
screws [2] you removed in step 7).
52
[3]
[2]
[1]
[1]
[2]
[2]
F-1-165
12) Mount the right cover (upper rear) you removed in
step 5).
13) Connect the power plug, and turn on the main
power switch.
14) Start service mode, and make the following
selections: COPIER>FUNCTION>INSTALL>KEY:
then, enter '1'.
15) Turn off and then on the main power switch.
16) Check to see that a message has appeared asking
for the control key.
17) Insert the control key, and check to make sure that
the machine is ready to make copies.
[1]