Canon iR C6800 Series Installation Procedure page 27

F-1-59
4) Turn the developing cylinder gear by hand to look
for scratches on the cylinder.
5) Peel off the tape [2] used to keep the high-voltage
cable [1] in place.
F-1-60
6) Hold the black developing assembly [1] by both its
ends; while keeping it level, fit it in place while
pushing it downward at an angle.
At this time, be sure that the boss [2] at the rear of the
developing assembly matches the left guide [3] of the
machine.
Be sure also that the rib [4] at the front of the
developing assembly matches the right guide at the
front of the machine.
[1]
[2]
[1]
[2]
[2]
[1]
[5]
[4]
F-1-61
When fitting the black developing assembly in the
machine, try keeping the high-voltage cable [1] on top
of the assembly. Otherwise, the cable can get trapped
when the assembly is put inside the machine.
[1]
F-1-62
7) Route the cable [1] having the tube of the black
developing assembly through the hole [2] indicated in
the figure.
Chapter 1
[3]
19