Mounting The Color Developing Assemblies - Canon iR C6800 Series Installation Procedure

[2]
F-1-43
1. Be sure to take care not to deform the joint plate
found at the left end when drawing out the process
unit.
2. When drawing out the process unit, be careful not
to lift the process unit more than necessary. The unit
may slip off the rails, not permitting detachment.
3. When you have slid out the process unit, try placing
paper between the photosensitive drum and the
developing rotary to protect the drum from scratches
and light.
1.2.7 Mounting the Color
Developing Assemblies
iR C6800C / iR C6800CN / iR 5800C / iR 5800CN
If you must touch a color developing assembly, be
sure that your hands are free of foreign matter
(especially of metal) before dong so. (Adhesion of
foreign matter on the cylinder is likely to cause image
faults.)
1) Take out the color developing assembly (yellow,
magenta, cyan) from its package box.
2) Push the lever [1] of the developing rotary solenoid
once by hand; then, turn the developing rotary [2]
counterclockwise by hand.
If you turn the developing rotary clockwise with a
[1]
0002-6670
color developing assembly fitted in place, the anti-
stray sheet attached to the sleeve of the color
developing assembly can come off by friction against
the photosensitive drum. Be sure to turn the
developing rotary always in counterclockwise
direction.
F-1-44
3) Turn the developing rotary so that its partition side
[1] is vertical (i.e., position for mounting the
developing assembly).
If you keep pushing the lever of the developing
rotary solenoid, the developing rotary will not stop to
permit mounting the developing assembly. When you
have pushed the lever once, turn the developing rotary
slightly and then let go of the lever.
O
90
F-1-45
4) Peel off the protective sheet [1] from the toner
supply mouth of the developing rotary.
Chapter 1
[1]
[2]
[1]
15