Canon iR C6800 Series Installation Procedure page 25

[1]
F-1-50
10) Check for scratches on the developing cylinder
while turning the developing cylinder gear [1] 5 to 6
times in the direction of the arrow. The work also
serves to even out the starter inside the unit.
F-1-51
11) Make sure that the color developing assembly
matches the ID mark; then, fit it in the developing
rotary.
To do so, start with the front of the color developing
assembly; while keeping its front fully against the
front of the developing assembly, fit its rear in place.
Try holding the color developing assembly by
both its ends to facilitate the work.
F-1-52
12) Close the 2 developing assembly fixing arms [1]
[2]
[1]
in the direction of the arrows; then, fix them in place
using 2 screws [2].
[1]
[1]
[2]
F-1-53
13) Repeat steps from 2) to 12) to fit all 3 color
developing assemblies in the developing rotary.
14) If the developing cylinder [1] is found as in the
figure marked NG, turn the developing rotary so that
it is positioned as shown in the figure marked OK.
(Good position)
OK
[1]
NG (Bad position)
[1]
F-1-54
15) Loosen the screw [2] used to hold the torque
limiter [1] of the developing rotary in place; then,
slide it upward to release.
Chapter 1
[2]
17