HP 3500 Series Advanced Traffic Management Manual page 247

HP Switch(config)# qos dscp-map af11 priority 3
HP Switch(config)# qos dscp-map 13 priority 3
HP Switch(config)# qos dscp-map af13 priority 3
HP Switch(config)# write memory
HP Switch(config)# show config
HP Switch configuration:
; J9146 Configuration Editor; Created on release W.14.XX
hostname "Switch"
time daylight-time-rule None
qos dscp-map af11 priority 3
qos dscp-map 13 priority 3
qos dscp-map af13 priority 3
.
.
.
Figure 5-6. Assigning Priorities to the Selected DSCPs
3. Assign the DSCP policies to the selected TCP/UDP port applications and
display the result.
HP Switch(config)# qos udp-port 23 dscp 000111
HP Switch(config)# qos tcp-port 80 dscp 000101
HP Switch(config)# qos tcp-port 914 dscp 000010
HP Switch(config)# qos udp-port range 1001 2000 dscp 000010
TCP/UDP port based priorities
| IP Packet Application
Protocol | Type
-------- + --------- ----------- ---------- + ------ -----------
UDP | IPV4
TCP | IPV4
TCP | IPV4
UDP | IPV4
Global TCP/UDP port-
number classifiers
Figure 5-7. Configuring a DSCP Policy for Global TCP/UDP Port Classifiers
The switch applies the DSCP policies in Figure 5-7 to IP packets with the
specified TCP/UDP port applications that are received in the switch. The
switch manages the packets as follows:
Quality of Service: Managing Bandwidth More Effectively
Show config lists the non
default codepoint settings.
Port Apply rule | DSCP
23 DSCP
80 DSCP
914 DSCP
1001-2000 DSCP
DSCP Policy: DSCP codepoint (3) and 802.1p priority (1)
mapping (Note: DSCP 3 is the decimal equivalent of binary
000010.)
Globally-Configured QoS
Configure these three codepoints
with non-default priorities.
|
Priority
| 8 7
| 6 5
| 3 1
| 3 1
5-29