HP 3500 Series Advanced Traffic Management Manual page 281

Syntax: no interface < port-list > qos
Disables use of the specified source-port(s) for QoS classi-
fier(s) and resets the priority for the specified source-port(s)
to No-override.
Syntax: show qos port-priority
Lists the QoS port-priority classifiers with their priority
data.
Example. This example shows how to prioritize inbound traffic on the
following source-ports:
Source-Port Priority
A1 - A3 2
A4 3
B1, B4 5
C1-C3 6
Enter the following commands to prioritize packets received from the speci-
fied source ports:
HP Switch(config)# interface 1-3 qos priority 6
HP Switch(config)# interface 4-5 qos priority 5
HP Switch(config)# interface 6-7 qos priority 3
Switch(config)# show qos port-priority
Port priorities
Port Apply rule
---- ----------- + ------ ----------- ---------------
1 Priority
2 Priority
3 Priority
4 Priority
5 Priority
6 Priority
7 Priority
8 No-override |
9 No-override |
10 No-override |
Figure 5-28. Configuring and Displaying Source-Port QoS Priorities
If you later decided to remove source-port A1 from QoS prioritization, you
would enter the following command:
Quality of Service: Managing Bandwidth More Effectively
| DSCP Priority
| 6
| 6
| 6
| 5
| 5
| 3
| 3
No-override No-override
No-override No-override
No-override No-override
Globally-Configured QoS
Radius Override
No-override
No-override
No-override
No-override
No-override
No-override
No-override
5-63