HP 3500 Series Advanced Traffic Management Manual page 165

Displaying Per-Instance MSTP Configurations. These commands dis-
plays the per-instance port configuration and current state, along with
instance identifiers and regional root data.
Syntax: show spanning-tree config instance < ist | 1..16 >
The upper part of this output shows the instance data for the
specified instance. The lower part of the output lists the
spanning-tree port settings for the specified instance.
Syntax: show spanning-tree < port-list > config instance < ist | 1..16 >
This command shows the same data as the above command,
but lists the spanning-tree port parameter settings for only the
specified port(s) and/or trunk(s). You can list data for a series
of ports and port trunks by specifying the first and last port
or trunk of any consecutive series of ports and trunks. For
example, to display data for port A20-A24 and trk1, use this
command:
show spanning-tree a20-a24,trk1 config instance 1
HP Switch(config)# show spanning-tree config instance 11
MST Instance Configuration Information
Instance ID : 11
Switch Priority : 32768
Mapped VLANs : 111,300
Port Type
----- --------- + --------- --------
1 10/100TX
2 10/100TX
3 10/100TX
4 10/100TX
Figure 3-24. Example of the Configuration Listing for a Specific Instance
Multiple Instance Spanning-Tree Operation
Displaying MSTP Statistics and Configuration
| Cost Priority
| Auto 128
| Auto 128
| Auto 128
| Auto 128
Instance-Specific Data
Port Settings for the
specified instance.
3-57