Displaying Loop Protection Status In Vlan Mode - HP 3500 Series Advanced Traffic Management Manual

HP Switch(config)# show loop-protect 1-2
Status and Counters - Loop Protection Information
Transmit Interval (sec)
Port Disable Timer (sec)
Loop Detected Trap
Loop Protect Mode
Loop Protect Enabled VLANs :
Loop Loop
Port Protect Detected on VLAN
---- ------- -------- --------- -------- ----------- ----------
1 Yes Yes
2 Yes No
Figure 3-36. Example of Show Loop-Protect Output for Port Mode
: 5
: 5
: Enabled
: Port
Detected Loop
Count
NA 1
NA 0

Displaying Loop Protection Status in VLAN Mode

Toe display information about loops on VLANs with loop protection enabled,
enter the show loop-protect command.
Syntax: show loop-protect <port-list>
Displays the loop protection status for VLANs. If no ports are
specified, the information is displayed only for the ports that
have loop protection enabled.
Multiple Instance Spanning-Tree Operation
Time Since Rx
Last Loop Action
5s send-disable
send-disable
Loop Protection
Port
Status
---------
Down
Up
3-77