Table of Contents
Advertisement
MESSAGES ON THE DISPLAY
MESSAGE
TOP OPEN
REM. DOCUMENT
NO INK
CHECK PAPER
NO HEAD
HEAD NEW?
YES = CONF. NO = CLEAR
CHECK NOZZLES
HANDSET OFF HOOK
OPERATION INTERR
NO DOCUMENT
DIAGNOSTIC ON
cap16.p65
109
SIGNALS AND SERVICE CODES
SOLUTION
Close the lid of the operator console.
Remove the document and replace it correctly in
the feed slot.
With a disposable print head, replace the head.
With a print head with an interchangeable ink cartridge,
replace the cartridge.
If the message persists, replace the print head. See the
"MAINTENANCE" chapter.
Add paper to the cassette and check the position of
the paper positioning lever.
Insert the print cartridge. If the message appears even
when the cartridge is present in the facsimile machine, it
has proprobably been inserted incorrectly. In this case,
remove and reinsert the cartridge.
If the message persists, clean the electrical contacts (see
the "Cleaning the electrical contacts" section of the
"MAINTENANCE" chapter.
This message appears on the display after the print
cartridge has been inserted. If the cartridge is new, select
YES by pressing SET/CONF. ; if it is not, select NO by
pressing CLEAR .
WARNING: If you select YES and the cartridge is not
new, the no ink left status will not be detected.
Follow the print head nozzle purging procedure.
Should faults be found, act according to the diagnostic
result printed (see the "Checking the print head nozzles"
section of the "MAINTENANCE" chapter).
If the message persists, replace the print cartridge.
Place the handset on the hook.
This message appears on the display for a few seconds
when you interrupt a procedure in progress.
Insert the document in the ADF.
When powered on, the facsimile machine runs a short
test on its components and then gets ready for operation.
At the end of the procedure, check that the facsimile
machine is in stand-by.
13/04/00, 23.07
109
Advertisement
Table of Contents
