Table of Contents
Advertisement
PROGRAMMING
If the key has already been programmed, the display
shows the number of the programmed fax user.
If this is the case, select a different key (using ∨ ∨
or ∧ ∧ ) or change the value displayed, see the "Clearing
programmed data" section.
5.
Press START .
The facsimile machine is set for entry of the parameters
to be associated with the selected one-touch dialling
key.
If you want to skip a parameter, simply press the ∨ ∨
or ∧ ∧ key. Each time either of these is pressed, the
next parameter will be displayed.
6.
Press START to start entering the selected parameter,
e.g. "FAX NO."
7.
Enter the relevant facsimile number (max. 32 digits)
on the numeric keypad, e.g. 0125 45812.
By pressing the ∗ key, you can switch to tone dialling.
The "∗" symbol appears on the display.
If the display shows a previously set number, you can
confirm it by pressing SET/CONF. , or replace it with
a new number by typing the new number on the
numeric keypad and pressing SET/CONF. .
To delete a setting, press CLEAR .
To make a correction, move the cursor to the digit to
be changed (using the < or > key) and overwrite it
with the new digit.
If you want to leave a blank between one digit and
another, use the > key to move the cursor one
position forward.
By pressing EXT./PAUSE you can insert one or more
pauses (during dialling) between the digits in the
number. The pause is identified on the display by the
character "p".
It's a good idea to insert a pause between the code
and the number. In some countries, an answering
tone must be heard before the whole number can be
dialled. In this case, press 2nd DIAL TONE . The
display shows the symbol ":".
20
cap05.p65
20
1 - T O U C H
6 :
E N T E R
E N T E R
.
0 1 2 5 4 5 8 1 2
13/04/00, 22.17
F A X N O .
F A X N O .
F A X N O
+
Advertisement
Table of Contents
